Blog Category: FABRICATED PIPE SHOES, GUIDES & ANCHORS

Piping Technology & Products, Inc. designed and fabricated several pipe shoes with loads up to 75,000 lbs. respectively, for a 750MW power plant in Alabama.

The shoes are to support the cooling towers’ circulatory water system at the power plant. The majority of the shoes were designed for a 60″ line and 50,000 lb. load, and the remaining few were designed for a 78″ line and 75,000 lbs. of load. After extensive engineering hours and structure analysis, PT&P’s engineering department was able to produce a detailed design and 3-D model for the supports that would allow them to run electronic interface checks.

Do you need pipe shoes? Get pricing today!

Piping Technology & Products, Inc., designed and fabricated a Figure 700 chrome-moly shoe for an 18″ pipe used to support high temperature lines at a power plant in Mexicali, Mexico.

The shoe’s length is 12″ and the pipe centerline distance was maintained at 17 3/8″ from the bottom of the shoe. The clamp was designed at 1065°F and the load was designed for 6965 pounds. The base and clamp plates are made of A387 GR.22 plate material and the u-bolt parts are made of A193 GR.B7 bar stock.

Want to learn more about chrome-moly shoes and other products from Piping Technology and Products? Visit our webinar archives today!

Piping Technology & Products, Inc. fabricated cryogenic pipe supports designed for a 14-inch pipe at a LNG plant in Algeria. The pipe operates below minus 50 degrees F, therefore the pipe supports were fabricated from three different materials in order to accommodate the low temperatures. The upper part, which clamps on to the pipe, was fabricated from a stainless steel plate that retains its strength at low temperatures. The middle section is a laminated phenolic block made from layers of wood impregnated under vacuum with a synthetic resin. A crossed orientation of the hard wood fibers is used to provide extra strength. The laminated phenolic block, which is a poor conductor of heat, was bolted to the bottom plate of the galvanized carbon steel.

Are you in need of some cryogenic pipe supports for an upcoming project? Get pricing today!

This photograph shows a number of 60” pipe shoes fabricated by Piping Technology & Products, Inc. of Houston, TX for export to Saudi Arabia. The Saudi Arabian Oil Company is purchasing a variety of sizes of this type of shoe and other items required for piping on their projects. Piping Technology furnishes all types of pipe supports including PTFE, 25% glass filled, and graphite slide plates, anchors and insulated pipe shoes.

Want to learn more about pipe shoes? Learn more from one of our previous webinars!